Top latest Five cutting concrete rebar Urban news



Decorative Concrete of Austin
Austin, TX, USA
http://decorativeconcreteofaustin.com
+1 512-909-5812

Install pressure dealt with sleepers. We advocate using 3/4″ thick strain taken care of decking. Use foam board adhesive along the bottom from the sleepers and in addition attach the sleepers for the concrete using masonry nails or a powder actuated nailer.

Your countertops look stunning and so contemporary and brilliant. So delighted to suit your needs Kristi and now it’s A further Major task ticked off your to perform list. Your kitchen area is going to look like a whole new kitchen area at the time it’s all again jointly with your new cabinetry coloration! Can’t await The brand new reveal.

You encouraged using four-6 screws for each Advantec board. Because it can be a T&G, this means that screws must set pn the edges or you have to place tapcons all around Just about every board.

I don’t Consider using a sealer is essential. I do think as long as you put down the foam and seal the seams perfectly there will be no issue.

“Ought to we install a six mil vapor barrier very first, and after that position the tiles along with that, for far better safety vs achievable dampness seeping from the tiles up into the finished floor?”

two. The house is about seven a long time previous and there are actually slight settling cracks from a single aspect on the basement to one other (no proof of any water problems) Do I ought to seal/repair service these cracks just before I put the pink board down?

I searched and searched online and so far I’ve only observed a single resource (this one) for polyurea sold in realistic amounts (i.e., an amount that a DIYer would need for countertops, rather than industrial sized containers for business use), and it was only obtainable while in the shiny finish.

Not acquainted with DryPly read more about stained concrete austin nonetheless it’s most likely much like AdvanTech. DRI-Core is a superb products and we’ve employed it before. I wouldn’t place it on insulation. Even so, it is likely to make the floor Substantially hotter. According to their web site there needs to be no attachement:

But considering that the ground is so soaked I’m worried about vapor developing with the concrete. That’s why I’m leaning a lot more toward something that allows a little bit through in lieu of sealing it with an entire vapor barrier like I did the walls.

And if so, I have already got my walls up so, would I seal the poly up equally as it meets my stress handled base plate? no gaps?

Also, would you propose Barricade or DriCore if we do not need have plenty of for more about concrete floors austin headroom to try and do XPS foam/sleepers/subfloor?

It is going to bring out the colour of whichever is beneath it simply a bit (just like how water-primarily based polyurethane, even though clear, will continue to bring out the colour of your wood just a little bit), however it’s obvious with no yellow or amber or another shade to it in the least.

Just wondering if it’s advised to complete the floor before the walls in foam board… I’m hoping to accomplish the walls to start with as our governing administration (canada) presents grants for insulating basement walls after which I was likely to do the floor while in the futures…

Todd I reside in Lubbock Texas had many rain basement is leaking experienced about 36 gallons of water I damp vac.up. Good read more about decorative concrete austin friend of mine stated to use swimming pool paint to seal the basement floor and walls.

Leave a Reply

Your email address will not be published. Required fields are marked *